old man emu Posted yesterday at 06:08 AM Posted yesterday at 06:08 AM 5 hours ago, red750 said: WD-40 is supposed to be the be all and end all of thread looseners. It wasn't created for that purpose. It was created as a water dispersant to remove moisture from NASA rockets. Hence the WD part of the name. The -40 arises from the fact that it was the fortieth mixture brewed up by the developers to do the job. There are plenty of other penetrants that do a better job. These range from the DIY 50/50 acetone/transmission fluid to stuff like Kroil and Mouse Milk. I've even seen stuck engine pistons freed by pouring in some kerosene and giving the top of the piston a bit of a tap with a hammer handle over a few days. Obviously in that sort of case, time is not a factor in the repair. I watch a lot of videos where people use WD-40 to free rust-seized nuts, bolts or screws. I often notice that as the threaded section of the fastener is exposed, it is not wet very far down the shaft. I reckon most of that is sprayed on just floods over the surrounding surfaces. Any proprietory penetrant is expensive - mostly in the cost of packaging and retailing. My preference is acetone and ATF. 1
Admin Posted yesterday at 06:20 AM Posted yesterday at 06:20 AM What about Penetrene? A mechanic friend of mine called it "Hens Piss" and always swore by it 2
facthunter Posted yesterday at 08:04 AM Posted yesterday at 08:04 AM There's a skill in freeing rusted nuts. Sometimes you split them with hole and a chisel. Other times heat them and force all the water out, Make it convert from Hydrated Iron oxide to the black one. Put some Penetrene there for a while and move it a bit both ways, till it frees up with a good fitting ring or socket spanner. . Nev
old man emu Posted yesterday at 08:56 AM Posted yesterday at 08:56 AM 48 minutes ago, facthunter said: move it a bit both ways One technique I have seen is to turn the nut, bolt or screw in the tightening direction a bit. That seems to break the "seal" caused by the rust. Doesn't always work, but worth a try before employing brute force and ignorance. I should add that you do this after letting some penetrating fluid soak a bit. 2 hours ago, Admin said: What about Penetrene? I was only trying to name a few penetrants. There's a million and one proprietory ones on the market.
facthunter Posted 7 hours ago Posted 7 hours ago I would NOT suggest moving it in the tightening direction first unless it fixing something like a fence Post. The heating is very effective with Wheel spokes. You can often save them that way. Nev
facthunter Posted 2 hours ago Posted 2 hours ago Loosen it a bit FIRST, but the concept of moving it gradually in both directions is sound. It helps work the Penetrene or what-ever through the thread, and saves the Hex. from being rounded off, or the stud snapping. If in doubt drill a hole and split the Nut, both sides IF necessary. Stuff operating near Salt water can be difficult. Grade 4 Auto bolts are tough. Getting spark plugs out of alloy heads where no anti seize has been used is also tricky. A helicoil is not really a satisfactory FIX there, and a staked in threaded Bush isn't either. Prevention is better than repair. Nev
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now