old man emu Posted 21 hours ago Posted 21 hours ago 5 hours ago, red750 said: WD-40 is supposed to be the be all and end all of thread looseners. It wasn't created for that purpose. It was created as a water dispersant to remove moisture from NASA rockets. Hence the WD part of the name. The -40 arises from the fact that it was the fortieth mixture brewed up by the developers to do the job. There are plenty of other penetrants that do a better job. These range from the DIY 50/50 acetone/transmission fluid to stuff like Kroil and Mouse Milk. I've even seen stuck engine pistons freed by pouring in some kerosene and giving the top of the piston a bit of a tap with a hammer handle over a few days. Obviously in that sort of case, time is not a factor in the repair. I watch a lot of videos where people use WD-40 to free rust-seized nuts, bolts or screws. I often notice that as the threaded section of the fastener is exposed, it is not wet very far down the shaft. I reckon most of that is sprayed on just floods over the surrounding surfaces. Any proprietory penetrant is expensive - mostly in the cost of packaging and retailing. My preference is acetone and ATF. 1
Admin Posted 21 hours ago Posted 21 hours ago What about Penetrene? A mechanic friend of mine called it "Hens Piss" and always swore by it 2
facthunter Posted 19 hours ago Posted 19 hours ago There's a skill in freeing rusted nuts. Sometimes you split them with hole and a chisel. Other times heat them and force all the water out, Make it convert from Hydrated Iron oxide to the black one. Put some Penetrene there for a while and move it a bit both ways, till it frees up with a good fitting ring or socket spanner. . Nev
old man emu Posted 18 hours ago Posted 18 hours ago 48 minutes ago, facthunter said: move it a bit both ways One technique I have seen is to turn the nut, bolt or screw in the tightening direction a bit. That seems to break the "seal" caused by the rust. Doesn't always work, but worth a try before employing brute force and ignorance. I should add that you do this after letting some penetrating fluid soak a bit. 2 hours ago, Admin said: What about Penetrene? I was only trying to name a few penetrants. There's a million and one proprietory ones on the market.
facthunter Posted 1 hour ago Posted 1 hour ago I would NOT suggest moving it in the tightening direction first unless it fixing something like a fence Post. The heating is very effective with Wheel spokes. You can often save them that way. Nev
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now