Jump to content

Recommended Posts

Posted
5 hours ago, red750 said:

WD40ad..thumb.JPG.e6b8f547ba24e93a6e22315db19318ac.JPG

WD-40 is supposed to be the be all and end all of thread looseners. It wasn't created for that purpose. It was created as a water dispersant to remove moisture from NASA rockets. Hence the WD part of the name. The -40 arises from the fact that it was the fortieth mixture brewed up by the developers to do the job.

 

There are plenty of other penetrants that do a better job. These range from the DIY 50/50 acetone/transmission fluid to stuff like Kroil and Mouse Milk. I've even seen stuck engine pistons freed by pouring in some kerosene and giving the top of the piston a bit of a tap with a hammer handle over a few days. Obviously in that sort of case, time is not a factor in the repair.

 

I watch a lot of videos where people use WD-40 to free rust-seized nuts, bolts or screws. I often notice that as the threaded section of the fastener is exposed, it is not wet very far down the shaft. I reckon most of that is sprayed on just floods over the surrounding surfaces. Any proprietory penetrant is expensive - mostly in the cost of packaging and retailing. My preference is acetone and ATF.

  • Like 1
Posted

There's a skill in freeing rusted nuts. Sometimes you split them with hole and a chisel. Other times heat them and force all the water out, Make it convert from Hydrated Iron oxide to the black one. Put some Penetrene there for a while and move it a bit both ways, till it frees up with a good fitting ring or socket spanner. .  Nev

Posted
48 minutes ago, facthunter said:

move it a bit both ways

One technique I have seen is to turn the nut, bolt or screw in the tightening direction a bit. That seems to break the "seal" caused by the rust. Doesn't always work, but worth a try before employing brute force and ignorance. I should add that you do this after letting some penetrating fluid soak a bit.

 

2 hours ago, Admin said:

What about Penetrene?

I was only trying to name a few penetrants. There's a million and one proprietory ones on the market.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...