old man emu Posted 1 hour ago Posted 1 hour ago 5 hours ago, red750 said: WD-40 is supposed to be the be all and end all of thread looseners. It wasn't created for that purpose. It was created as a water dispersant to remove moisture from NASA rockets. Hence the WD part of the name. The -40 arises from the fact that it was the fortieth mixture brewed up by the developers to do the job. There are plenty of other penetrants that do a better job. These range from the DIY 50/50 acetone/transmission fluid to stuff like Kroil and Mouse Milk. I've even seen stuck engine pistons freed by pouring in some kerosene and giving the top of the piston a bit of a tap with a hammer handle over a few days. Obviously in that sort of case, time is not a factor in the repair. I watch a lot of videos where people use WD-40 to free rust-seized nuts, bolts or screws. I often notice that as the threaded section of the fastener is exposed, it is not wet very far down the shaft. I reckon most of that is sprayed on just floods over the surrounding surfaces. Any proprietory penetrant is expensive - mostly in the cost of packaging and retailing. My preference is acetone and ATF. 1
Admin Posted 1 hour ago Posted 1 hour ago What about Penetrene? A mechanic friend of mine called it "Hens Piss" and always swore by it 2
facthunter Posted 2 minutes ago Posted 2 minutes ago There's a skill in freeing rusted nuts. Sometimes you split them with hole and a chisel. Other times heat them and force all the water out, Make it convert from Hydrated Iron oxide to the black one. Put some Penetrene there for a while and move it a bit both ways, till it frees up with a good fitting ring or socket spanner. . Nev
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now